Home > Forums > General Forums > Main CFD Forum

Time Step in sonicFoam

Updated Threads

Reply

Search this Thread

May 3, 2014, 19:08	Time Step in sonicFoam	#1
MhamadAlloush New Member Mhamad Alloush Join Date: May 2014 Posts: 1 Rep Power: 0	Hello guys I was simulating my own 3D airfoil on a MACH 2.4 using sonicFoam. As I ran the problem, it took too many time so I interrupted it at some point. Note that in my system I have a very fine tetrahedral mesh at the boundary of the airfoil; the total number of cells is not less than 1 million. How to solve that? I had tried to increase the time step in the controlDict file but the simulation diverged eventually. Hope that somebody did 3D supersonic simulation using sonicFoam.

Reply

Tags

sonicfoam, supersonic

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
High Courant Number @ icoFoam	Artex85	OpenFOAM Running, Solving & CFD	11	February 16, 2017 14:40
Extrusion with OpenFoam problem No. Iterations 0	Lord Kelvin	OpenFOAM Running, Solving & CFD	8	March 28, 2016 12:08
calculation stops after few time steps	sivakumar	OpenFOAM Running, Solving & CFD	7	March 17, 2013 07:37
Full pipe 3D using icoFoam	cyberbrain	OpenFOAM	4	March 16, 2011 10:20
calculation diverge after continue to run	zhajingjing	OpenFOAM	0	April 28, 2010 05:35

All times are GMT -4. The time now is 17:09.