 |
 |
 |
|
|
|
[Sponsors] | ||||
July 30, 2006, 23:06
|
fully developed duct flow
|
#1 |
|
Guest
Posts: n/a
|
For a fully developed laminar flow in square duct, does anyone know the ratio of maximum velocity/bulk velocity? Thanks.
|
|
|
||
|
July 31, 2006, 08:43
|
Re: fully developed duct flow
|
#2 |
|
Guest
Posts: n/a
|
isn't the max flow at the centerline for fully developed flow equal to 1.5*Vin? I don't know if this applies to a a square duct though.
|
|
|
|
||
|
August 2, 2006, 20:00
|
Re: fully developed duct flow
|
#3 |
|
Guest
Posts: n/a
|
For a square duct you calculate the equivalent hydraulic diameter Dh=4*Area/(Wetted perimeter) and can do mean velocity calculations.Check any introductory book on fluid mechanics.
-H |
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Fully developed flow in Star-cd | SMM | STAR-CD | 3 | September 9, 2011 16:54 |
| Fully Developed Flow in Star-cd | SMM | STAR-CD | 0 | September 5, 2011 23:08 |
| Fully developed flow profile | icfd | Main CFD Forum | 3 | May 20, 2009 23:21 |
| Writing an expression for fully developed flow! | Usman | CFX | 12 | December 20, 2007 12:26 |
| udf for 3D laminar fully developed flow | salman | FLUENT | 0 | November 9, 2006 22:45 |
Linear Mode
