 |
 |
 |
|
|
|
[Sponsors] | ||||
June 16, 2006, 14:34
|
Modeling die coating
|
#1 |
|
Guest
Posts: n/a
|
I am concerned with designing the die lip for a die coating process. I have to study a existing design and see if it is ok and if not I have to think about redesigning it. What kind of tools/books/softwares would help me to do this. Will a software like Floworks help me in any way?
Thanks -Pradeep |
|
|
||
|
June 16, 2006, 16:02
|
Re: Modeling die coating
|
#2 |
|
Guest
Posts: n/a
|
I know a couple of the codes (STAR-CD and CFX as far as I can recall) were looking at coating processes I doubt FloWorks will do want you want, what are you coating it with and what are the physics involved?
|
|
|
|
||
|
June 16, 2006, 16:30
|
Re: Modeling die coating
|
#3 |
|
Guest
Posts: n/a
|
Thanks for the reply Ben.
It is a slot die coating process, for some details you could refer the following link. http://www.yasui.com/2004/slotdie.htm -Pradeep |
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| May Focus Area: Turbulence Modeling | Jonas Larsson | CFD-Wiki | 0 | May 2, 2006 12:48 |
| Modeling Flow/Saturation/Absorption in Fibers | Gene Dougherty | Main CFD Forum | 0 | June 6, 2003 15:49 |
| Solid Modeling | Chris | Main CFD Forum | 10 | July 2, 2002 08:12 |
| CFD Modeling of Two-phase Flow in Small Dia.Tubes | Eric Poindexter | Main CFD Forum | 2 | September 22, 2000 10:21 |
| Extrusion Modeling | Elliot Schwartz | Main CFD Forum | 1 | September 11, 1998 20:08 |
Linear Mode
