|
[Sponsors] |
April 21, 2006, 18:21 |
KIVA3V2R injection problem
|
#1 |
Guest
Posts: n/a
|
I met an injection problem when simulating SI engine with KIVA. 1. The prog ran well if there is no injection. 2. The prog crashed when injection was applied. (Error message showed velocity or temp interation over limit, dt reduced gradually, finally went to 10e-10. then program stopped) 3. It looks like crash happened when droplet hit the wall. Any help will be appriciated! Thanks in advanced!
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Problem Importing Geometry ProE to CFX | fatb0y | CFX | 3 | January 14, 2012 20:42 |
Can I solve this problem by Fluent? | Kai_kc | FLUENT | 1 | October 27, 2010 06:29 |
natural convection problem for a CHT problem | Se-Hee | CFX | 2 | June 10, 2007 07:29 |
Adiabatic and Rotating wall (Convection problem) | ParodDav | CFX | 5 | April 29, 2007 20:13 |
DPM injection problem | akr | FLUENT | 5 | November 6, 2006 11:34 |