boundary layer -- CFD Online Discussion Forums

November 23, 2005, 04:43	boundary layer	#1
Fer Guest Posts: n/a	Hi all! I'm trying to simulate the flow over a car in 2D. I'm using Tri elements for the mesh (run in Gambit). My doubt is that I don't know the convenience or not in using boundary layers to define the mesh in those regions closer to the car's surface. Can anybody give me advise about it and, in that case, the criterion to select the thicknes of that boundary layer? Thanks all, again Fer

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Gmsh] Default Faces on Boundary Layer	axel	OpenFOAM Meshing & Mesh Conversion	8	February 17, 2011 08:47
Boundary Layer Question	scottneh	STAR-CCM+	3	September 30, 2010 15:21
Adapt mesh without modifying boundary layer cells?	Freeman	FLUENT	0	February 22, 2009 15:11
3D Boundary Layer	Mario	FLUENT	0	February 17, 2009 04:40
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues	michele	OpenFOAM Meshing & Mesh Conversion	2	July 15, 2005 05:15

All times are GMT -4. The time now is 23:48.