 |
 |
 |
|
|
|
[Sponsors] | ||||
May 17, 2017, 10:51
|
must have (faces-blocks)=0
|
#1 |
|
Member
Mike
Join Date: Jun 2012
Posts: 58
Rep Power: 14  |
Hi Guys,
I am a new user of grid pro. A professor has given me a mesh he would like me to use including the files [geo.bnd, geo.grd, geo.fra, geo.sch]. I opended up the .fra file and then went to ggrid:start. However I was getting an error that: must have (faces-blocks)=0 1 found. A picture is attached. How do I fix this problem?I would like to just generate the mesh and export it to ansys icem cfd which I have been using. Any help would be greatly appreciated. Is there anyway to just use the .grd file and generate the mesh? I can also send the .fra files. Thanks, dreamchaser |
|
|
|
|
|
June 1, 2017, 17:24
|
|
#2 |
|
Member
Sam
Join Date: Mar 2009
Posts: 35
Rep Power: 17 |
Hi Mike, can you post the topology here?
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Decomposing meshes | Tobi | OpenFOAM Pre-Processing | 22 | February 24, 2023 10:23 |
| [snappyHexMesh] Error snappyhexmesh - Multiple outside loops | avinashjagdale | OpenFOAM Meshing & Mesh Conversion | 53 | March 8, 2019 10:42 |
| [snappyHexMesh] No layers in a small gap | bobburnquist | OpenFOAM Meshing & Mesh Conversion | 6 | August 26, 2015 10:38 |
| SigFpe when running ANY application in parallel | Pj. | OpenFOAM Running, Solving & CFD | 3 | April 23, 2015 15:53 |
| snappyhexmesh remove blockmesh geometry | philipp1 | OpenFOAM Running, Solving & CFD | 2 | December 12, 2014 11:58 |
Linear Mode
