Problem with create a interface

ingenieroelder · January 27, 2012, 18:00

Hi friends, this is my firt time here, well my problem is I'm trying to simulate the convective heat transfer of a MiniCanal, but i am trying of many forms to crate theinterfce but it results bada all my option because the fluid don't show any heat transfer, i upload the picture of my project for any help, thanks anyway.

preview.png

it see the way of the fluid.

shk12345 · January 28, 2012, 01:15

there must be something wrong with your case putup in fluent.

Do you put up the heat transfer at the walls of the surface where you want the heat transfer to be taken place.

Check your case properly

shk

January 27, 2012, 18:00	Problem with create a interface	#1
ingenieroelder New Member ingeniero Join Date: Jan 2012 Posts: 2 Rep Power: 0	Hi friends, this is my firt time here, well my problem is I'm trying to simulate the convective heat transfer of a MiniCanal, but i am trying of many forms to crate theinterfce but it results bada all my option because the fluid don't show any heat transfer, i upload the picture of my project for any help, thanks anyway. preview.png it see the way of the fluid.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Wind turbine simulation	Saturn	CFX	60	July 17, 2024 06:45
How to create interface in VOF model of ANSYS/Fluent	shambansal2010	Fluent Multiphase	14	April 5, 2017 02:03
Actuator disk model	audrich	FLUENT	0	September 21, 2009 08:06
Interface problem	Tomislav	FLUENT	4	May 23, 2006 01:49
CAD Interface problem	sweenam	Phoenics	0	November 9, 2002 07:08

January 28, 2012, 01:15		#2
shk12345 Senior Member shoeb khan Join Date: Nov 2011 Posts: 179 Rep Power: 15	there must be something wrong with your case putup in fluent. Do you put up the heat transfer at the walls of the surface where you want the heat transfer to be taken place. Check your case properly shk