creation of mesh for boundary layer in Fluent Meshing Tool

fferroni · December 7, 2011, 11:20

Hello.

It's the first time I use the FLUENT Meshing Tool and need some help.
I've got a very simple square tube, and would like to make a square element mesh, that is very well refined at the edge, and quite refined in all other areas.
I set the 'relevance' factor to 100, and then used the Inflation tool, selecting the various wall of the geometry. This creates very fine step meshes near the walls, but in the center the elements become triangular rather than square. Is there a way to simply maintain square elements whilst increasing definition near walls?

Thank you.

Kind Regards,

Francesco

mashinsazi · December 7, 2011, 15:24

Meshing is not a science.It's a kind of art.Just be creative.

A_Lyaskin · December 8, 2011, 06:05

You need to define your meshing method explicitly. For your case it's better to use Sweep. And remember the pecularities of inflation with sweep - you'll need to specify edges, not surfaces.

December 7, 2011, 11:20	creation of mesh for boundary layer in Fluent Meshing Tool	#1
fferroni Member Join Date: Nov 2011 Posts: 44 Rep Power: 15	Hello. It's the first time I use the FLUENT Meshing Tool and need some help. I've got a very simple square tube, and would like to make a square element mesh, that is very well refined at the edge, and quite refined in all other areas. I set the 'relevance' factor to 100, and then used the Inflation tool, selecting the various wall of the geometry. This creates very fine step meshes near the walls, but in the center the elements become triangular rather than square. Is there a way to simply maintain square elements whilst increasing definition near walls? Thank you. Kind Regards, Francesco

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[snappyHexMesh] Number of cells in mesh don't match with size of cellLevel	colinB	OpenFOAM Meshing & Mesh Conversion	14	December 12, 2018 09:07
fluent doesnt read 1D coating mesh - advice needed	FuzzyDice	FLUENT	5	September 28, 2011 17:34
[snappyHexMesh] I wonder, how do I mesh a car?	MadsR	OpenFOAM Meshing & Mesh Conversion	0	May 2, 2011 16:39
[snappyHexMesh] Boundary layer generation problems	ivan_cozza	OpenFOAM Meshing & Mesh Conversion	0	October 6, 2010 14:47
How to control Minximum mesh space?	hung	FLUENT	7	April 18, 2005 10:38

December 7, 2011, 15:24		#2
mashinsazi New Member kamran Join Date: Apr 2011 Posts: 17 Rep Power: 15	Meshing is not a science.It's a kind of art.Just be creative.

December 8, 2011, 06:05		#3
A_Lyaskin Member Anton Lyaskin Join Date: Mar 2009 Location: Samara, Russia Posts: 66 Rep Power: 17	You need to define your meshing method explicitly. For your case it's better to use Sweep. And remember the pecularities of inflation with sweep - you'll need to specify edges, not surfaces.