 |
 |
 |
|
|
|
[Sponsors] | ||||
fluid/solid heat transfer for a welding model |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
June 30, 2011, 17:10
|
fluid/solid heat transfer for a welding model
|
#1 |
|
New Member
Gemma
Join Date: Jun 2011
Posts: 1
Rep Power: 0  |
Hi,
I have modelled the nozzle of the welding torch sitting above a solid plate in a fluid volume and have represented the arc as a hemispherical energy source sitting on the plate directly below the nozzle. My problem is no matter how high I set the energy source, the heat transfer from fluid to solid is limited and definatley not represening reality. I'm fairly new to FLUENT so I'm not sure if I'm missing something glaringly obvious. Any help would be appreciated! Last edited by gramsey629; July 8, 2011 at 04:52. |
|
|
|
|
|
| Tags |
| fluid-solid, heat transfer, welding |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Heat Transfer convergence Problem mit a 1/6 compressor model | chili023 | CFX | 1 | January 15, 2011 07:41 |
| model forced convection heat transfer on a heat sink | farzad | FLUENT | 0 | September 9, 2010 15:48 |
| error in model heat transfer of bimetal blade | njiit | FLUENT | 0 | October 7, 2009 06:49 |
| heat transfer with s2s radiation model in fluent | D. L. | FLUENT | 3 | July 31, 2008 08:40 |
| Water vapour condensation in CFX-5.7.1 | hdj | CFX | 1 | November 27, 2005 08:15 |
Linear Mode
