 |
 |
 |
|
|
|
[Sponsors] | ||||
June 15, 2011, 16:59
|
Dynamic mesh frequency
|
#1 |
|
New Member
Herman
Join Date: May 2011
Posts: 8
Rep Power: 15  |
Hi all!
I have implemented a dynamic mesh to simulate the blade motion through a rowing simulator (swimming pool for rowers to train) I have implemented CG_MOTION and found good results. How does one incorporate a frequency to the moving wall? Thus sweeping through the domain, disappearing and appearing again where it was? I have vel[0] = 1 at the moment. This should have some time source or something? Any help will be greatly appreciated for my final year skripsie Thank you |
|
|
|
|
|
June 15, 2011, 17:05
|
|
#2 |
|
New Member
Herman
Join Date: May 2011
Posts: 8
Rep Power: 15 |
If someone can lend me guidance for multiphase flow it will aslo help me very much. I have implemented air and water as primary and secondary phases repectively but when I inspect the mixture with contours I only see the whole domain filled with water or air.
How does one specify where the "layer" should be? Thank you |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Incylinder dynamic mesh with volumetric reaction | mas | FLUENT | 4 | May 3, 2012 11:22 |
| Dynamic Mesh moving interface help | akash.iitb | FLUENT | 0 | August 24, 2010 00:53 |
| Dynamic mesh + grid adapt = Crash! (Files included | BillH | FLUENT | 4 | July 24, 2007 16:31 |
| Dynamic Mesh | Pj | FLUENT | 1 | March 12, 2007 16:16 |
| Help: Is it possible to use dynamic mesh model and | Valery Ponyavin | FLUENT | 1 | September 20, 2003 15:18 |
Linear Mode
