 |
 |
 |
|
|
|
[Sponsors] | ||||
May 11, 2011, 04:59
|
visualize wall deposition
|
#1 |
|
New Member
Jovana Milenkovic
Join Date: May 2011
Posts: 10
Rep Power: 15  |
Hello everybody,
I am a beginner in working with FLUENT 6.2, and I was wondering if someone can help me or give me some advice or instruction...  So, I wont to visualize particle deposition on a wall at my model that I have. It's not Wall Surface Reaction. How can I do it? Is there more than one possibility? I am reading Fluent Manual but I can't find the chapter and information that I need... Thank you in advance. Kind Regards 
|
|
|
|
|
|
May 11, 2011, 05:10
|
|
#2 |
|
Senior Member
Bernhard
Join Date: Sep 2009
Location: Delft
Posts: 790
Rep Power: 22 |
I always use a DEFINE_DPM_OUTPUT on the wall, to write the deposition location, and then visualize in Tecplot.
|
|
|
|
|
|
|
May 11, 2011, 09:30
|
|
#3 |
|
New Member
Jovana Milenkovic
Join Date: May 2011
Posts: 10
Rep Power: 15 |
Thank you!
|
|
|
|
|
|
 |
| Tags |
| fluent 6.2, visualize wall deposition |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Commercial meshers] Fluent3DMeshToFoam | simvun | OpenFOAM Meshing & Mesh Conversion | 50 | January 19, 2020 16:33 |
| Natural convection in a closed domain STILL NEEDING help! | Yr0gErG | FLUENT | 4 | December 2, 2019 01:04 |
| species deposition or wall reaction ? | gianfilippo | FLUENT | 2 | August 21, 2012 14:19 |
| Errors running allwmake in OpenFOAM141dev with WM_COMPILE_OPTION%3ddebug | unoder | OpenFOAM Installation | 11 | January 30, 2008 21:30 |
| Multicomponent fluid | Andrea | CFX | 2 | October 11, 2004 06:12 |
Linear Mode
