boundary conditions for 3D channel flow with heat transfer

Aloex · February 21, 2011, 15:14

Hi user's,

I`m actually simulating a flow in a 3D channel. The dimensions of the channel are 5mm x 0.5mm x 15mm. So it is a very short channel with a lenght of 15mm. The inlet is a mass-flow-inlet, the channel wall is a wall and the outlet is a pressure-outlet (0bar). And the operating pressure is set to 1bar.
Now I´m not sure about the correct thermal boundary conditions. The compressible fluid has a temperature of 293.15K at the inlet and the wall get the isothermal temperature of 1273.15K. At the outlet I set the temperature for the pressure-outlet to 293.15K... Is this right?
I want to have the average temperature of the fluid at the outlet, but there I say with the boundary conditions that the temperature is 293.15K... It is not a conflict with my target? Furthermore I want to get the heat flow from the wall to the fluid, but this should be ok.

Thank you for your help!

Regards,
Aloex

Aloex · February 22, 2011, 13:28

I solved the problem by my self. For a pressure-outlet boundary condition must define the backflow temperature... So it isn`t the temperature like you have to define at a mass-flow-inlet.

February 21, 2011, 15:14	boundary conditions for 3D channel flow with heat transfer	#1
Aloex New Member Join Date: Mar 2010 Location: Germany Posts: 10 Rep Power: 16	Hi user's, I`m actually simulating a flow in a 3D channel. The dimensions of the channel are 5mm x 0.5mm x 15mm. So it is a very short channel with a lenght of 15mm. The inlet is a mass-flow-inlet, the channel wall is a wall and the outlet is a pressure-outlet (0bar). And the operating pressure is set to 1bar. Now I´m not sure about the correct thermal boundary conditions. The compressible fluid has a temperature of 293.15K at the inlet and the wall get the isothermal temperature of 1273.15K. At the outlet I set the temperature for the pressure-outlet to 293.15K... Is this right? I want to have the average temperature of the fluid at the outlet, but there I say with the boundary conditions that the temperature is 293.15K... It is not a conflict with my target? Furthermore I want to get the heat flow from the wall to the fluid, but this should be ok. Thank you for your help! Regards, Aloex

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Periodic boundary conditions in 3D Eulerian granular flow simulations	dsm	FLUENT	4	March 2, 2012 20:04
Open Channel Flow - Setting Boundary Conditions	Christine Sindelar	FLUENT	6	June 6, 2011 05:11
Concentric tube heat exchanger (Air-Water)	Young	CFX	5	October 7, 2008 00:17
Convective Heat Transfer - Heat Exchanger	Mark	CFX	6	November 15, 2004 16:55
Please help with flow around car modelling!	Tudor Miron	CFX	17	March 19, 2004 20:23

February 22, 2011, 13:28		#2
Aloex New Member Join Date: Mar 2010 Location: Germany Posts: 10 Rep Power: 16	I solved the problem by my self. For a pressure-outlet boundary condition must define the backflow temperature... So it isn`t the temperature like you have to define at a mass-flow-inlet.