|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
Kim Donghee
Join Date: May 2009
Posts: 15
Rep Power: 17 ![]() |
hi everyone
i'm UDF user and beginner. it's very simple problem and just check the results. 30 * 56 rectangular domain left, right wall is adiabatic conditions bottom wall is constant temperautre at 373K top wall is convective boundary condition with h=5 W/m^2, T_infinite = 298K. 1. if energy equation in fluent, it's too easy. just set up the h & T_infinite. 2. this is my question. i want to use udf and hope that get a same result which uesd energy equation in fluent. also, i don't know about heat flux at top wall. therefore, i don't wanna use "DEFINE_PROFILE" subfunction. anyone know this problem?? |
|
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
isothermal wall boundary condition | Neil | Main CFD Forum | 3 | November 9, 2015 02:34 |
Wall boundary condition (a very simple question) | safa_c | FLUENT | 1 | August 15, 2010 05:05 |
RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 04:05 |
how to set up a wall boundary condition according to calculated wall shear stress? | gameoverli | OpenFOAM Pre-Processing | 1 | May 21, 2009 08:28 |
UDF hook on the WALL boundary condition | Luke | FLUENT | 0 | June 7, 2006 11:54 |