|
[Sponsors] |
December 1, 2010, 00:34 |
Plz. help me:Plain-Orifice Atomizer
|
#1 |
New Member
Kitipon
Join Date: Oct 2010
Posts: 16
Rep Power: 16 |
Hi all,
Could anyone suggest me how i can find conner radius curvature and orifice length for fogging nozzle inside the greenhouse? and what is the most suitable model for fogging nozzle ? anyway,I am so doubt when I changed inner diameter or injection pressure for pressure swirl atomizer,ther is no change in evaporation rate.Does anyone know about this? Cheer |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
2D axisymmetric mass flow rate for the plain orifice atomizer | jwillie2000 | FLUENT | 2 | September 17, 2010 06:43 |
Need help in modeling flow through orifice | kunal | Main CFD Forum | 0 | April 16, 2010 10:12 |
Flow past orifice | aurel | Main CFD Forum | 0 | January 27, 2009 07:46 |
azimuthal angle in plane orifice atomizer model | sina | FLUENT | 0 | September 23, 2008 02:23 |
Orifice Flow | Prateep Chatterjee | FLUENT | 4 | February 23, 2001 15:59 |