 |
 |
 |
|
|
|
[Sponsors] | ||||
October 13, 2010, 10:46
|
Solution not Converged for a Blower
|
#1 |
|
New Member
Dinesh Babu
Join Date: Oct 2010
Location: Bangalore
Posts: 23
Rep Power: 16      |
Hi,
I am running a Flow simulation for a Blower rotating at 1000 rpm. The Flow is 2D with K-Episilon Turbulence model. The Inlet and Outlet conditions are set to Pressure Inlet and Pressure Outlet. With the increased pressure inlet, I run the simulation in Fluent.. The Problem, the solution is not converged.. The Residual plot remains at the same level no matter how many iterations. Need your Ideas please.. If the above details are insufficient, please let me know.. Last edited by devanson; October 13, 2010 at 15:14. Reason: insufficient data |
|
|
|
|
|
October 10, 2014, 01:26
|
Closing a thread
|
#2 |
|
New Member
Dinesh Babu
Join Date: Oct 2010
Location: Bangalore
Posts: 23
Rep Power: 16 |
Hi,
How can I close or delete the unwanted threads?
__________________
Dinesh Babu CFD Engineer |
|
|
|
|
|
 |
| Tags |
| blower, converge, fluent, solution |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Solution converged, and then diverge again. | jrg | FLUENT | 2 | April 2, 2013 00:10 |
| IcoFoam parallel woes | msrinath80 | OpenFOAM Running, Solving & CFD | 9 | July 22, 2007 03:58 |
| Modelling a crossflow blower | PAD | FLUENT | 0 | August 30, 2006 02:38 |
| Could anybody help me see this error and give help | liugx212 | OpenFOAM Running, Solving & CFD | 3 | January 4, 2006 19:07 |
| converged solution or correct solution | SAM | FLUENT | 1 | October 12, 2004 16:38 |
Linear Mode
