|
[Sponsors] |
July 29, 2010, 10:21 |
asking help for porous media simulation
|
#1 |
New Member
jim
Join Date: Nov 2009
Posts: 1
Rep Power: 0 |
I do the calculation, non-steady state, the porous medium model, two-dimensional rectangular grid, laminar flow, gas flow through from top to bottom, the upper material layer is cooled, the lower part is heated. Initially, the upper surface of the gas temperature at the same height cross section is the same, very flat. But over time, the gas temperature difference occurs at the same height. Actual physical process, at the same height position, the gas temperature should be the same. what is the problem , who can tell me?thank you so much!!!!!
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Pressure Drop/Porous Media within Shrouded Wind Turbine Simulation | joshdsouza | FLUENT | 0 | March 3, 2010 19:02 |
Turbulent and non-turbulent region simulation | peterle | CFX | 0 | December 15, 2009 11:26 |
Replacing mesh while running a simulation | akultane | CFX | 1 | November 15, 2009 14:46 |
Three-Phase Simulation Through Porous Media | Sanjib | FLUENT | 0 | July 17, 2005 13:49 |
Simulation of Porous Media Flow | Sharad Dugad | FLUENT | 0 | December 24, 2001 02:57 |