|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
Join Date: Jun 2010
Posts: 7
Rep Power: 16 ![]() |
HiI'm simulating the flow between 2 rotating cylinders. I use the rng k-epsilon-model and defined a velocity inlet and pressure outlet, the Fluid is defined as water. The wall is defined as a moving wall, but if I increase the rotation to 2000rpm or higher,the swirl velocity drops to almost zero between the two cylinders or the residuals remain high and oscillating (maybe because I have reversed flow on the outlet?)The problem occurs in 2D and 3D.Is there a possibility to stop the reversed flow? I already tried a different mesh or slowly decreasing the under-relaxation factors.regards,peter
|
|
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Rotating cylinders | rathish | FLUENT | 8 | June 22, 2010 17:22 |
Rotating Cylinders | rathish | FLUENT | 0 | April 6, 2010 06:45 |
ROTATING cYLINDERS | rathish | OpenFOAM Running, Solving & CFD | 0 | March 23, 2010 06:34 |
Rotating coaxial cylinders | Xiana | FLUENT | 0 | May 28, 2007 10:33 |
PROBLEMS WITH ROTATING FLOW BETWEEN TWO CYLINDERS | vitmalin | CFX | 2 | October 11, 2006 07:22 |