 |
 |
 |
|
|
|
[Sponsors] | ||||
How to set Solution Initialization in transient |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
June 17, 2010, 04:33
|
How to set Solution Initialization in transient
|
#1 |
|
New Member
Jason
Join Date: Aug 2009
Posts: 2
Rep Power: 0  |
Dear all.
I am simulating a tank filling case in transient model, the inlet is downside, and fill in tank under the pressure--40Kpa. The pressure in the tank is 20KPa. How should I set the Solution Initialization? Set the "Gauge Pressure" as 20KPa or set the velocity in directly? Thank u in advance. |
|
|
|
|
|
June 17, 2010, 07:30
|
|
#2 |
|
New Member
Mark Bell
Join Date: Apr 2010
Location: Holywood
Posts: 12
Rep Power: 16 |
you could initialise it in the standard way, then patch the pressures to particular regions
|
|
|
|
|
|
|
June 17, 2010, 08:54
|
|
#3 |
|
New Member
Jason
Join Date: Aug 2009
Posts: 2
Rep Power: 0 |
Dear mebll10,
"initialise it in the standard way", U mean initialise it with default setting? or can initialise "from inlet"? Thank U. Best Regards. Jason |
|
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Installation problems | indy | OpenFOAM Installation | 7 | April 3, 2009 10:40 |
| Problem in installation of OpenFOAM | sachin | OpenFOAM Installation | 7 | January 22, 2008 02:40 |
| How to set environment variables | kanishka | OpenFOAM Installation | 1 | September 4, 2005 11:15 |
| How to divide the transient Solution file | Narmin B Hushmandi | Siemens | 4 | January 19, 2005 09:00 |
| Wall functions | Abhijit Tilak | Main CFD Forum | 6 | February 5, 1999 02:16 |
Linear Mode
