Combustion SImulation in Fluent

santhosh1987 · May 14, 2010, 11:33

hi everyone !

Am performing a non-premixed combustion simulation of gas turbine engine in fluent. its a 30 deg axisymmetric 3D model. i was trying to run the continuous phase. but i get the following error.
Temperature limited to 1 in zones 2 and 3

and the solution is converged in 1 iteration.

i know its wrong. please someone help me with this. also it would be of immense help if someone can provide me with some useful information in running combustion modelling in fluent.

argeus · May 14, 2010, 17:03

Hi,
firstly, carefully check the BCs set up and the material properties..

May 14, 2010, 11:33	Combustion SImulation in Fluent	#1
santhosh1987 New Member santhosh Join Date: May 2010 Posts: 7 Rep Power: 16	hi everyone ! Am performing a non-premixed combustion simulation of gas turbine engine in fluent. its a 30 deg axisymmetric 3D model. i was trying to run the continuous phase. but i get the following error. Temperature limited to 1 in zones 2 and 3 and the solution is converged in 1 iteration. i know its wrong. please someone help me with this. also it would be of immense help if someone can provide me with some useful information in running combustion modelling in fluent.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Diesel combustion simulation ( Heat release rate)	venkatesh	Siemens	2	April 29, 2009 08:38
Fluent simulation over airships	Aragon	FLUENT	8	March 30, 2009 13:12
Fluent simulation over airships	Aragon	FLUENT	0	March 27, 2009 13:38
Scratch Space Error during combustion simulation	Emmanuel Kasseris	Siemens	10	October 25, 2008 18:12
combustion study using Fluent	L. Li	Main CFD Forum	1	August 9, 2000 06:36

May 14, 2010, 17:03		#2
argeus New Member Ján Join Date: Mar 2010 Location: Slovakia Posts: 24 Rep Power: 16	Hi, firstly, carefully check the BCs set up and the material properties..