|
[Sponsors] |
July 8, 2009, 22:55 |
temperature limited warning in 1 cell
|
#1 |
Senior Member
|
Hi all
I am running a simulation of Ariane 5 structured on Fluent with SA turbulence model. After few iterations it showed me warnings like temperature limited and pressure limited to 1 in 3 cells. Although 3 out of 2.4 million is not a big number but the Mach number at his region is 38 which is physically not possible. ActuallyI have to see the separation region between booster and outer central nozzle. These 2 cells are in that region unfortunately. I am doing this as a thesis and I dont have much time guys so please help me ASAP. It must be noted that its very very very very difficult to go to mesh again and improve that problem cheers |
|
April 3, 2014, 04:00 |
Temperature limit to 5000
|
#2 |
Member
subhas hunasikatti
Join Date: Sep 2013
Posts: 32
Rep Power: 13 |
Hello Shamoon Jamshed,
I am also getting the message like temperature limited to 5000 in 744 cells on zone 8 in domain1 while solving 3D-heat transfer problem in fluent, If u know the solution for this problem or regarding this please reply me. Thank you with regards SUBHAS |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Compilation errors in ThirdPartymallochoard | feng_w | OpenFOAM Installation | 1 | January 25, 2009 06:59 |
OpenFOAM14 for Mac OSX Darwin 104 | gschaider | OpenFOAM Installation | 118 | July 20, 2008 05:19 |
[blockMesh] Axisymmetrical mesh | Rasmus Gjesing (Gjesing) | OpenFOAM Meshing & Mesh Conversion | 10 | April 2, 2007 14:00 |
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |
Warning 097- | AB | Siemens | 6 | November 15, 2004 04:41 |