 |
 |
 |
|
|
|
[Sponsors] | ||||
June 7, 2009, 01:11
|
Changing Reynolds Number
|
#1 |
|
New Member
Join Date: Jun 2009
Posts: 1
Rep Power: 0  |
Hi everybody,
I'm modelling in Fluent a Jet entering a wind tunnel. It's a transient problem and after a while I need to increase the Reynolds number without initialize the simulation. Initial Reynolds number was introducing setting a boundary condition of velocity. How can I change the reynolds number in order to study how can that change affects the results. Thanks in advance |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [mesh manipulation] Mesh Refinement | Luiz Eduardo Bittencourt Sampaio (Sampaio) | OpenFOAM Meshing & Mesh Conversion | 42 | January 8, 2017 13:55 |
| DecomposePar unequal number of shared faces | maka | OpenFOAM Pre-Processing | 6 | August 12, 2010 10:01 |
| [blockMesh] BlockMeshmergePatchPairs | hjasak | OpenFOAM Meshing & Mesh Conversion | 11 | August 15, 2008 08:36 |
| Unaligned accesses on IA64 | andre | OpenFOAM | 5 | June 23, 2008 11:37 |
| [Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 05:15 |
Linear Mode
