 |
 |
 |
|
|
|
[Sponsors] | ||||
How to set the wind tunnel Boundary conditions in Fluent??? |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
April 13, 2009, 15:12
|
How to set the wind tunnel Boundary conditions in Fluent???
|
#1 |
|
Senior Member
Saima
Join Date: Apr 2009
Location: Canada
Posts: 185
Rep Power: 16  |
Hi ,
I have a problem in which a heater is on leading edge of an airfoil, placed in wind tunnel. Air is inside the tunnel at -5C. And water spray by using atomizer is also there. This airfoil is placed inside the wind tunnel.I want to setup the boundary conditions. I took, 1. Velocity inlet (bcoz i know the initial velocity which is constant in entire process) 2. Outflow 3. The bottom and top wall (wall with zero shear) I want to know what could be the boundary conditions for top and bottom walls of Wind tunnel?  It is very urgent. Many Many thanks in advance. Regards, Saima |
|
|
|
|
|
April 14, 2009, 01:12
|
|
#2 |
|
New Member
Raheel Rasool
Join Date: Apr 2009
Posts: 7
Rep Power: 17 |
You can take them as wall and specify zero as shear value to avoid boundary layer generation there and cross flow across the wall.
Just an idea!!! Regards, Raheel |
|
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Fluent - boundary conditions | Vijay | FLUENT | 3 | January 9, 2009 12:42 |
| Sloshing Boundary Conditions in Fluent | Prabodh | FLUENT | 0 | April 16, 2006 06:52 |
| Gambit boundary conditions not suitable for fluent | ann | FLUENT | 3 | October 12, 2005 13:51 |
| UDF to set boundary conditions | philip | FLUENT | 2 | June 17, 2005 10:11 |
| Please help with flow around car modelling! | Tudor Miron | CFX | 17 | March 19, 2004 20:23 |
Linear Mode
