 |
 |
 |
|
|
|
[Sponsors] | ||||
January 3, 2009, 00:11
|
How Fluent calculates pressure?
|
#1 |
|
Guest
Posts: n/a
|
I did a simple test: set a block with all sides as wall boundary. then a constant mass addition in this block. I expect pressure increases with time during simulation. However, the pressure in the block just doesn't change. Does anyone have a clue on this? THanks.
|
|
|
||
|
January 3, 2009, 14:23
|
Re: How Fluent calculates pressure?
|
#2 |
|
Guest
Posts: n/a
|
 )) how do you add the mass to your system? is your problem transient? do you use an udf to increase the mass?
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| is it true that FLUENT calculates Nusselt wrong? | muhittin | FLUENT | 1 | February 14, 2010 04:51 |
| The pressure in Fluent | danny | FLUENT | 2 | October 26, 2004 10:48 |
| Pressure value in fluent? | WU zhonghua | FLUENT | 0 | August 6, 2004 03:15 |
| How CFX calculates forces | Marco Aurelio Melo | CFX | 5 | January 26, 2004 09:01 |
| Pressure BCs in FLUENT | Julien | Main CFD Forum | 2 | May 13, 1999 21:16 |
Linear Mode
