Error messages

January 2, 2009, 01:50

What is the problem with my mesh when this message is shown :"Cannot change rack_inlet to fan because there is only one adjacent cell thread"

Im trying to set a face named "rack inlet" as a fan BC but this message keep appearing.

Help needed. thanks!

January 3, 2009, 11:28

Please explain how you created the face in GAMBIT.

January 5, 2009, 01:03

Hi zongtwi,

I created a block (i.e rack) and meshed the whole volume using "HEX" elements and "Map" type with spacing of 0.2. This block is inside a larger block (i.e room) and i'm trying to simulate flow from the rack within the room.

Do i need to do any Boolean operations? Any steps which i missed out?

Thanks for your response =)

January 2, 2009, 01:50	Error messages	#1
laisquared Guest Posts: n/a	What is the problem with my mesh when this message is shown :"Cannot change rack_inlet to fan because there is only one adjacent cell thread" Im trying to set a face named "rack inlet" as a fan BC but this message keep appearing. Help needed. thanks!

January 3, 2009, 11:28	Re: Error messages	#2
zongtwi Guest Posts: n/a	Please explain how you created the face in GAMBIT.

January 5, 2009, 01:03	Re: Error messages	#3
laisquared Guest Posts: n/a	Hi zongtwi, I created a block (i.e rack) and meshed the whole volume using "HEX" elements and "Map" type with spacing of 0.2. This block is inside a larger block (i.e room) and i'm trying to simulate flow from the rack within the room. Do i need to do any Boolean operations? Any steps which i missed out? Thanks for your response =)

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Error Messages	Blade	CFX	2	February 14, 2023 14:54
ERROR #001100279 and Error-Messages in general	Andreas	CFX	2	July 31, 2019 07:03
Error Messages	Derick	FLUENT	0	September 22, 2005 10:54
Error Messages	Ale	FLUENT	1	April 22, 2005 08:09
Error Messages !	Bharath	FLUENT	3	December 6, 2002 10:56