|
[Sponsors] |
Change wall boundary condition in multiphase? |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 27, 2008, 07:26 |
Change wall boundary condition in multiphase?
|
#1 |
Guest
Posts: n/a
|
Hi folks,
I want to simulate an inflight-icing problem. My first step is to check the collection efficency (how many droplets impinge on the geometry) of the geometry with the DPM-Model and with a multiphase-model (euler-euler). Now I want to change the boundary condition of the wall, where the droplets impinge, with a UDF so that these droplets can escape the fluid-zone. The boundary condition must only change for the second phase (the phase with the water-droplets). In the DPM-Model this can be done by the "escape-bc". thanks for your help! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
rotating wall boundary condition in multiphase | sdp | FLUENT | 0 | February 16, 2009 22:12 |
change of boundary condition | Giacomo de Renzi | FLUENT | 9 | May 22, 2008 07:42 |
change boundary condition via UDF | gerhard zalusky | FLUENT | 2 | July 12, 2007 04:51 |
how to change emissivity at wall boundary | cthsieh | Siemens | 1 | August 29, 2006 00:04 |
UDF, using DEFINE_ADJUST to change a boundary condition | Jonas Larsson | FLUENT | 4 | March 21, 2000 19:51 |