doubt on specifying continuum types

October 21, 2008, 07:45

Hi, I'm modelling an axi-symmetric combustion problem. I divided my entire domain into 4 faces and meshed it. I then selected FLUID type for all four faces. While reading the case in FLUENT, it is not showing individual FLUID type that I have created in GAMBIT. Can anyone let me know their suggestions Thankyou

October 21, 2008, 21:37

Did you specify a FLUID domain for each face with a different name for each?

October 22, 2008, 00:46

Yes. I did. Can u tell me whether the edges that form the interface between these faces play any role? Should I assign INTEFACE boundary condition to these edges? Thanks for ur prompt reply

October 21, 2008, 07:45	doubt on specifying continuum types	#1
raghav Guest Posts: n/a	Hi, I'm modelling an axi-symmetric combustion problem. I divided my entire domain into 4 faces and meshed it. I then selected FLUID type for all four faces. While reading the case in FLUENT, it is not showing individual FLUID type that I have created in GAMBIT. Can anyone let me know their suggestions Thankyou

October 21, 2008, 21:37	Re: doubt on specifying continuum types	#2
CDE Guest Posts: n/a	Did you specify a FLUID domain for each face with a different name for each?

October 22, 2008, 00:46	Re: doubt on specifying continuum types	#3
raghav Guest Posts: n/a	Yes. I did. Can u tell me whether the edges that form the interface between these faces play any role? Should I assign INTEFACE boundary condition to these edges? Thanks for ur prompt reply

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Continuum boundary types for particle tracking	Prashanth	FLUENT	1	November 19, 2008 08:43
doubt on continuum	raghav	FLUENT	1	November 5, 2008 15:19
doubt on defining continuum type	raghav	FLUENT	0	October 24, 2008 00:39
How to solve 2 diferrent specify continuum types	tuw	FLUENT	2	October 28, 2006 12:30
Continuum-type	David	FLUENT	1	July 20, 2004 17:18