In reply to: "only one adjacent cell thread." -- CFD Online Discussion Forums

August 27, 2008, 21:39	In reply to: "only one adjacent cell thread."	#1
Krystian Guest Posts: n/a	I tried to add my two words to following post, but I couldn't find a way to do it - I think it is too old. http://www.cfd-online.com/Forum/flue...cgi/read/26492 Nonetheless, I encountered the same problem. Jason explains it well. However, before defining interface one needs to go to Define -> Boundary Conditions, choose the internal edges which couldn't be interpreted as INTERIOR and re-assign the INTERIOR boundary condition. If Fluent cannot read it, it will assign WALL boundary condition by default. After assigning INTERIOR proceed as Jason describes. Regards, Krystian

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Help! mesh error- "only one adjacent cell thread."	kuba	FLUENT	5	October 25, 2016 11:38
Accessing cell thread from a boundary face thread?	Vishal	FLUENT	2	March 21, 2006 08:29
how to connect faces(only one adjacent cell thread	BC	FLUENT	8	July 13, 2005 17:07
Adjacent cell number	Jing	Siemens	5	October 21, 2002 07:29
two adjacent cell zones.	Thejasvi	FLUENT	3	November 26, 2001 09:35

All times are GMT -4. The time now is 04:07.