 |
 |
 |
|
|
|
[Sponsors] | ||||
August 26, 2008, 11:55
|
Open channel flow
|
#1 |
|
Guest
Posts: n/a
|
Hi every body!
In Vof model, when I activate open channel flow option for inlet boundary condition I must choose "pressure inlet" or "mass flow inlet".I did it but I get wrong answer,the real head of water which is determined would not form. Maybe my mistake is in the inlet boundary options as in open channel flow options,In the fields "free surface level" and "bottom level" I put "the height of water" and "zero(bottom level of channel)". Is this true?(what is ylocal=-(a.g) in the manual?) Many thanks |
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Open Channel Flow | Ryan | FLUENT | 1 | March 17, 2008 11:10 |
| open channel VoF flow | Jim | FLUENT | 1 | August 23, 2007 20:47 |
| Open Channel Flow | Richard | CFX | 9 | May 31, 2007 20:57 |
| Open channel flow | Walid | Main CFD Forum | 1 | July 31, 2006 01:01 |
| open channel flow | Frank | Main CFD Forum | 3 | December 15, 2000 04:32 |
Linear Mode
