|
[Sponsors] |
![]() |
![]() |
#1 |
Guest
Posts: n/a
|
I have a model with these characteristics: tetrahedral mesh and heat generation within a porous zone, simulating steady state conditions. The simulation diverges in less than 10 iterations. The model runs smoothly and converges if I mesh it with wedges (exactly the same model!).
How dumb am I? |
|
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
UDF for Porous Zone | Evan | FLUENT | 1 | October 21, 2011 02:24 |
Porous jump & Porous zone - help needed | Witsarut Jintaworn | FLUENT | 3 | June 14, 2010 22:37 |
Heated porous zone | Norris | FLUENT | 0 | April 1, 2008 12:07 |
porous zone again | Edward Roj | FLUENT | 0 | May 10, 2005 07:11 |
Porous Zone | Chico Mbanu | FLUENT | 1 | July 21, 2004 07:23 |