Stationary wall and Moving wall

July 28, 2008, 22:29

hi,

in a 3d model, the outer chamber is a stationary wall & there is an internal classifier which is a moving wall & rotates at high rpm. how could i distinguish or set the boudary condition for these 2 walls. For meshing, do i need to substract the classifier unit from the overall chamber volume ? Please help. thanx.

sri

July 29, 2008, 05:33

If any wall is moving, the meshing should be a dynamic mesh. Use UDF DEFINE_CG_MOTION and represent the combined motion. Regards,

July 28, 2008, 22:29	Stationary wall and Moving wall	#1
Sri Guest Posts: n/a	hi, in a 3d model, the outer chamber is a stationary wall & there is an internal classifier which is a moving wall & rotates at high rpm. how could i distinguish or set the boudary condition for these 2 walls. For meshing, do i need to substract the classifier unit from the overall chamber volume ? Please help. thanx. sri

July 29, 2008, 05:33	Re: Stationary wall and Moving wall	#2
Tepin Joe Guest Posts: n/a	If any wall is moving, the meshing should be a dynamic mesh. Use UDF DEFINE_CG_MOTION and represent the combined motion. Regards,

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
moving wall...	kekko	CFX	0	February 2, 2007 14:11
Moving wall	skd	FLUENT	9	June 9, 2006 05:53
MOVING WALL	Michele	FLUENT	1	April 2, 2006 17:36
Moving wall	Shanti	FLUENT	2	March 21, 2006 00:04
pressure update at the stationary wall	Vinay Kumar	Main CFD Forum	4	June 10, 2005 07:10