Home > Forums > Software User Forums > ANSYS > FLUENT

Meshing difficulty in Gambit on a complex model

Updated Threads

Reply

Search this Thread

July 15, 2008, 22:52	Meshing difficulty in Gambit on a complex model	#1
Peter Guest Posts: n/a	Hi, I'm trying to mesh a centrifugal pump which was imported from Solidworks in Gambit but I found the green lines are confusing whenever I try to place nodes. Any tips? Thanks

July 16, 2008, 16:59	Re: Meshing difficulty in Gambit on a complex mode	#2
Vinod Dhiman Guest Posts: n/a	It might be just visual. Turn off silhoutte.

Reply

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
finding difficulty in dynamic meshing for ic engin	inderpreet saini	FLUENT	3	October 19, 2012 15:20
[Other] Meshing advice for complex domains	gregorv	OpenFOAM Meshing & Mesh Conversion	9	September 10, 2008 02:51
Gambit Meshing complex geometry	Edwin	FLUENT	2	July 19, 2006 16:02
Meshing a complex geometry	AJG	FLUENT	2	June 29, 2005 09:39
definition difficulty-->DO radiation model	Harry Qiu	FLUENT	0	March 29, 2001 10:19

All times are GMT -4. The time now is 05:18.