|
[Sponsors] |
June 23, 2008, 20:31 |
icem hexa mesh beginner
|
#1 |
Guest
Posts: n/a
|
hello, i am beginner in ICEM CFD.i have to simulate a flow over a NACA0015 airfoil.i have the final blocking.but when computing with pre-mesh,all geometry(the external flow+internal surface of airfoil)will be meshed.then i have to avoid the internal airfoil mesh. please,i will be grateful to receive any idea. thanks.
|
|
June 24, 2008, 06:02 |
Re: icem hexa mesh beginner
|
#2 |
Guest
Posts: n/a
|
Hi, Make the block of which is made in the internal of the airfoil as vforn(I dont exactly remember the name) when u hide the block inside the airfoil u get the mesh only on the external airfoil
|
|
July 9, 2008, 08:27 |
Re: icem hexa mesh beginner
|
#3 |
Guest
Posts: n/a
|
thanks a lot Ramesh. K.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
icem hexa mesh beginner | icem beginner | CFX | 3 | July 23, 2008 05:26 |
icem hexa mesh beginner | icem beginner | Main CFD Forum | 3 | July 9, 2008 08:08 |
Icem: Hexa-Mesh | john | CFX | 5 | April 3, 2008 10:49 |
HELP Beginner ICEM initialize PRE-MESH parameters | guest7777 | CFX | 2 | October 18, 2007 07:18 |
URGENT: HELP ICEM beginner mesh generation car | guest7777 | CFX | 13 | October 15, 2007 06:25 |