 |
 |
 |
|
|
|
[Sponsors] | ||||
June 19, 2008, 10:06
|
3D from axisymmetric results
|
#1 |
|
Guest
Posts: n/a
|
Hi,
Is there any post-processor that can make 3D from axisymmetric results ? |
|
|
||
|
June 22, 2008, 10:13
|
Re: 3D from axisymmetric results
|
#2 |
|
Guest
Posts: n/a
|
Hi, I am not getting from ur problem. Have u drawn a 2D axisymmetric body? If yes, then Fluent will take it as a 3D body with unit dimension in 3rd axis. This is only useful if the flow is symmetrical about the axis too e.g angle of attack given in a 2D symmetric airfoil (not cambered.
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| how to convert 3d results in 2D results | Ben | CFX | 1 | February 18, 2009 17:42 |
| Axisymmetric | rengu | OpenFOAM Running, Solving & CFD | 7 | April 26, 2008 14:29 |
| Modeling the flow in a fully axisymmetric case %e2%80%93 results with no peripheral symmetry | evgenia | OpenFOAM Running, Solving & CFD | 0 | February 14, 2008 11:23 |
| From 2D to axisymmetric | Nestor | FLUENT | 0 | February 3, 2008 13:33 |
| Axisymmetric Vof | Turbina | FLUENT | 8 | August 23, 2002 15:44 |
Linear Mode
