HOW TO MODEL PART OF THE BRUSH IN SLIDING MESH SYS -- CFD Online Discussion Forums

March 19, 2008, 06:26	HOW TO MODEL PART OF THE BRUSH IN SLIDING MESH SYS	#1
Xiangzhuan Zeng Guest Posts: n/a	HI In my research I want to model the hydrodynamic performances of the oxidation ditch, a widely used wastewater treatment equipment. The oxidation ditches are typically circular basins,the are typicaly areated at the top by the brush,but the brush are not totaly immerged into the water. Today I want to use fluent to model the rotation of the brushes,someone told me that just need to model the immerged part of the brush(http://dspace.lib.cranfield.ac.uk:80...0Gancarski.pdf) I do not underatand how to realize the drive of the brush in the water by just mesh the brush that is in water. How to realize it in fluent??

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Sliding mesh model problem	Usman	FLUENT	9	January 30, 2015 06:37
sliding mesh model	Usman	FLUENT	0	February 27, 2009 06:12
Sliding mesh model equations	Usman	FLUENT	0	July 14, 2008 08:03
sliding mesh model help	Usman	FLUENT	0	February 2, 2008 05:22
Sliding Mesh Model	alice	FLUENT	0	February 24, 2004 04:40

All times are GMT -4. The time now is 07:49.