|
[Sponsors] |
February 13, 2008, 04:13 |
convergence issue
|
#1 |
Guest
Posts: n/a
|
Hi All/Carlos (Carlos, I read your previous reply),
Problem: Fluid: diesel Geometry: Injector with one inlet and 2 outlets. Nozzle diameter 0.5mm. BC: Inlet pressure 5 Bar, Outlet pressure: atm. Mesh sensitivity: Three different meshes. One is 100% hexa. The run is not converging at all. I have tried to ramp up the BC gradually but no success yet. I have used the most basic models, still no success. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Convergence issue with continuity equation | Jake | FLUENT | 8 | June 6, 2018 04:41 |
Force can not converge | colopolo | CFX | 13 | October 4, 2011 23:03 |
convergence and off wall spacing issue | josip76 | FLUENT | 0 | June 4, 2011 19:13 |
Convergence of CFX field in FSI analysis | nasdak | CFX | 2 | June 29, 2009 02:17 |
Convergence issue in SST for Porous model | Raj | CFX | 0 | May 2, 2008 03:43 |