building geometry of an impeller in GAMBIT

February 4, 2008, 08:49

Hi! GAMBIT users

can we build an marine impeller with this given data?

1.three flat blades attached to the hub. 2.blade pitch angle 45 degrees 3.diameter 0.036m

If so,could you elaborate on the procedure?

Thanks PKN

February 4, 2008, 10:14

the model is built wiht the third software, like solidwork,e.g, then input into Gambit, where you will finish meshing, including setup hub,casing,period,etc; see the manual for further detail

February 4, 2008, 12:50

Thanks a lot jesse !

Is the data I mentioned earlier suffficient to build a geometry of impeller in the CAD?

Thanks PKN

February 5, 2008, 00:13

no. you need to have the profiles of blade, which has to be imported to ny CAD software or Gturbo

February 5, 2008, 04:16

Thanks a lot SAM!

may be, not the right thing to ask...how to get a blade profile of a three flat blade marine propeller with blade pitch angle of 45 degrees & having diameters of 0.036m.

Any way....Thanks a lot! PKN

February 5, 2008, 06:24

Do you have there goemtry with u or only physical part. ????

February 4, 2008, 08:49	building geometry of an impeller in GAMBIT	#1
PKN Guest Posts: n/a	Hi! GAMBIT users can we build an marine impeller with this given data? 1.three flat blades attached to the hub. 2.blade pitch angle 45 degrees 3.diameter 0.036m If so,could you elaborate on the procedure? Thanks PKN

February 4, 2008, 10:14	Re: building geometry of an impeller in GAMBIT	#2
jesse Guest Posts: n/a	the model is built wiht the third software, like solidwork,e.g, then input into Gambit, where you will finish meshing, including setup hub,casing,period,etc; see the manual for further detail

February 4, 2008, 12:50	Re: building geometry of an impeller in GAMBIT	#3
PKN Guest Posts: n/a	Thanks a lot jesse ! Is the data I mentioned earlier suffficient to build a geometry of impeller in the CAD? Thanks PKN

February 5, 2008, 00:13	Re: building geometry of an impeller in GAMBIT	#4
sam Guest Posts: n/a	no. you need to have the profiles of blade, which has to be imported to ny CAD software or Gturbo

February 5, 2008, 04:16	Re: building geometry of an impeller in GAMBIT	#5
PKN Guest Posts: n/a	Thanks a lot SAM! may be, not the right thing to ask...how to get a blade profile of a three flat blade marine propeller with blade pitch angle of 45 degrees & having diameters of 0.036m. Any way....Thanks a lot! PKN

February 5, 2008, 06:24	Re: building geometry of an impeller in GAMBIT	#6
sam Guest Posts: n/a	Do you have there goemtry with u or only physical part. ????

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
gambit open channel geometry	tplehn	FLUENT	1	July 21, 2009 13:04
Gambit geometry construction questions	yueke	FLUENT	0	June 25, 2009 15:50
3D geometry in gambit	Meenu	FLUENT	7	May 10, 2007 16:51
problem about Importing geometry in Gambit	Hua Gu	FLUENT	3	April 2, 2002 15:24
Creating a Geometry in GAMBIT	Sridhar	FLUENT	2	November 26, 2001 11:11