|
[Sponsors] |
![]() |
![]() |
#1 |
Guest
Posts: n/a
|
Hello, i am working in an aerodynamic modification on a car part, however the drawing of the part i have is a surface information and it defines an irregular surface actually it is a scanned and iported concave face. And for the cfd analysis i should carry, the part should bu turned into a closed solid.
can anybody suggest a software or a method to close this surface or turn it into a solid. |
|
![]() |
![]() |
![]() |
#2 |
Guest
Posts: n/a
|
there are many cad software that can do this, such as solidWork and pro-Engineer. may i knw what your purpose doing this simulation?
|
|
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Gmsh] Problem with Gmsh | nishant_hull | OpenFOAM Meshing & Mesh Conversion | 23 | August 5, 2015 02:09 |
Why the body is solid but not fluid when the NX file import into the DM? | ddx | ANSYS Meshing & Geometry | 1 | December 27, 2010 22:13 |
External Flow Prediction around a Car Body | S. | Main CFD Forum | 5 | June 5, 2007 22:40 |
Can I have solid in the free surface simulation? | ggbaby | Siemens | 0 | September 5, 2006 05:45 |
Please help about car body aerodynamic analysis | Tayfun Toraman | FLUENT | 2 | November 30, 2004 08:52 |