 |
 |
 |
|
|
|
[Sponsors] | ||||
December 29, 2007, 03:25
|
Fire Simulation
|
#1 |
|
Guest
Posts: n/a
|
Dear Friends,
I am doing fire simulation using species transport(volumetric heat source)in Fluent.I have selected methane-air mixture for this case.Can any one tell me that how the mass fraction is assigned?Is this air-methane mixture is suitable for predicting CO and fire somkeor any other mixture is better than this? I know CO in mg/m3, how to give it in terms of mass fraction? Again heat release rate should be 2MW.Is it needed to assign HRR at the walls? thnx in advance, Vishal |
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| AVL fire CI engine simulation neeed HELP ! | Mohsen khalafi | AVL FIRE | 1 | September 10, 2018 11:32 |
| NEED HELP on IC engine simulation with AVL FIRE! | Mohsen khalafi | Main CFD Forum | 2 | February 6, 2014 08:47 |
| smoke (fire simulation) | matt | Main CFD Forum | 0 | January 5, 2007 05:45 |
| FIRE simulation | T.H. Ko | Siemens | 3 | July 25, 2003 00:18 |
| Temperature errors on fire simulation? | raymond | Siemens | 0 | January 10, 2002 21:32 |
Linear Mode
