|
[Sponsors] |
what does nmake is invalid command [nmake] mean? |
![]() |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
![]() |
![]() |
#1 |
Guest
Posts: n/a
|
I get this message if I input nmake in the fluent window.
Does this mean I have not set C++ environment successfully? I have tried the setup twice and get this same result. Is there any other possible reasons? Thank you very much! |
|
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
gamma-ReTheta turbulence model for predicting transitional flows | FelixL | OpenFOAM Programming & Development | 123 | August 30, 2022 11:50 |
compilation problem with "fvPatch::lookupPatchField" | Ya_Squall2010 | OpenFOAM Programming & Development | 9 | November 15, 2021 22:01 |
[swak4Foam] GroovyBC the dynamic cousin of funkySetFields that lives on the suburb of the mesh | gschaider | OpenFOAM Community Contributions | 300 | October 29, 2014 18:00 |
OpenFOAM install on Ubuntu Natty 11.04 | bkubicek | OpenFOAM | 13 | May 26, 2011 05:48 |
Phase locked average in run time | panara | OpenFOAM | 2 | February 20, 2008 14:37 |