 |
 |
 |
|
|
|
[Sponsors] | ||||
December 20, 2007, 17:49
|
DPM iteration
|
#1 |
|
Guest
Posts: n/a
|
Hello
I am getting the following when attempting a DPM update: DPM iteration .... Can't figure which cell particle is going to -- ABORT Has anybody seen this before? Any suggestions on why this is goin on? Thanks for the help |
|
|
||
|
December 21, 2007, 05:48
|
Re: DPM iteration
|
#2 |
|
Guest
Posts: n/a
|
probably your time step for unsteady tracking is too large. fluid
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| DPM Iteration, incomplete | rookie | FLUENT | 9 | May 18, 2016 13:08 |
| DPM: Particle temperature at previous iteration step | sega | Fluent UDF and Scheme Programming | 0 | March 10, 2010 07:48 |
| DPM Time since last iteration | sega | Fluent UDF and Scheme Programming | 0 | February 25, 2010 06:52 |
| Parallel runs slower with MTU=9000 than MTU=1500 | Javier Larrondo | FLUENT | 0 | October 28, 2007 23:30 |
| DPM iteration | Marie | FLUENT | 1 | November 5, 2003 11:14 |
Linear Mode
