|
[Sponsors] |
December 4, 2007, 19:14 |
Error message-Floating point error
|
#1 |
Guest
Posts: n/a
|
Hi friends
I am running parallel version of fluent on a 4 processor workstation(Intel Xenon) After some no of iterations(particularly of the order of1,00,000) i am getting an error message in which the simulation stops. That iteration step value is being displayed in iterate dialog box time step value(I am doing unsteady state analysis) Error message- Floating point error. Please suggest me something. |
|
December 5, 2007, 07:19 |
Re: Error message-Floating point error
|
#2 |
Guest
Posts: n/a
|
hi Ensure your "grid check" is correct check your boundary conditions and initialise the solution properly
|
|
December 5, 2007, 22:47 |
Re: Error message-Floating point error
|
#3 |
Guest
Posts: n/a
|
Hi have the same problem I mark off at Iteration-Option-Data Sampling for Time statistics.I not sure rigth or worng But it's work.
|
|
December 7, 2007, 06:38 |
Re: Error message-Floating point error
|
#4 |
Guest
Posts: n/a
|
I am trying to solve cfd simulation of microchannel Geometry done in gambit. But in fluent floating error is ocured. please give suggestion on that, also tell me what is significance or cause of that floating error.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
c++ libraries and solver compiling | vaina74 | OpenFOAM Installation | 13 | February 3, 2012 18:43 |
Accessing phi from a fvPatchField at same patch | johndeas | OpenFOAM | 1 | September 13, 2010 21:23 |
Version 15 on Mac OS X | gschaider | OpenFOAM Installation | 113 | December 2, 2009 11:23 |
Problem with compile the setParabolicInlet | ivanyao | OpenFOAM Running, Solving & CFD | 6 | September 5, 2008 21:50 |
[Gmsh] Gmsh and samplesurface | touf | OpenFOAM Meshing & Mesh Conversion | 2 | December 10, 2007 03:27 |