extending boundary layer to mesh faces -- CFD Online Discussion Forums

September 28, 2007, 04:26	extending boundary layer to mesh faces	#1
kb Guest Posts: n/a	Hi I have enquiry in drawing the grid for a 3D pipe with boundary layer. I want know how i can divide the boundary layer into nodes then extending it to mesh the faces of the pipe? Is there anybody have idea about doing this? THanks for any suggestions kb

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ANSYS Meshing] Creating Hex Boundary Layer Mesh and Unstructured everywhere else	NLao	ANSYS Meshing & Geometry	1	March 15, 2011 07:35
Not able to mesh a helix with boundary layer using gambit	rohitjvbibin	FLUENT	1	March 7, 2011 05:40
[snappyHexMesh] Boundary layer generation problems	ivan_cozza	OpenFOAM Meshing & Mesh Conversion	0	October 6, 2010 14:47
RPM in Wind Turbine	Pankaj	CFX	9	November 23, 2009 05:05
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues	michele	OpenFOAM Meshing & Mesh Conversion	2	July 15, 2005 05:15

All times are GMT -4. The time now is 21:44.