icem 3d mesh for compressible flow with combustion -- CFD Online Discussion Forums

September 3, 2007, 12:46	icem 3d mesh for compressible flow with combustion	#1
James Guest Posts: n/a	Hi All, Has anyone created a tetra mesh in icemcfd 11.0 for compresible flow simulation with combustion in Fluent? I have done it but i keep having problems with convergence. For the cold flow, the steady flow residuals drops nicely and but when i switch to hot flow, the residuals begin to fluctuate......it is not the case if it is incompressible. The residuals for the fuel especially are showing sharp fluctuations. Any thoughts on why this is happening? Counting on your assistance. Jimmy

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
How to open Icem mesh in Ansys Fluent?	emmkell	FLUENT	27	February 6, 2018 04:34
3D Hybrid Mesh Errors	DarrenC	ANSYS Meshing & Geometry	11	August 5, 2013 07:42
[ICEM] Unstructure Meshing Around Imported Plot3D Structured Mesh ICEM	kawamatt2	ANSYS Meshing & Geometry	17	December 20, 2011 12:45
problem when converting mesh (made by ICEM) using fluentMeshToFoam	Forrest_Lei	OpenFOAM	11	October 16, 2009 07:28
ICEM CFD 5.1 Hex-Tet mesh merging failure	bogesz	CFX	1	January 29, 2005 07:46

All times are GMT -4. The time now is 13:28.