 |
 |
 |
|
|
|
[Sponsors] | ||||
August 7, 2007, 10:10
|
Polyhedral mesh in Fluent
|
#1 |
|
Guest
Posts: n/a
|
hai friends i have a doubt that is polyhedral meshing is availabel in Gambit or in ICEM CFD . Please send me some article link if possible.
regards shri |
|
|
||
|
August 8, 2007, 02:35
|
Re: Polyhedral mesh in Fluent
|
#2 |
|
Guest
Posts: n/a
|
Polyhedral isn't available in Gambit. You can only convert your tetrad mesh into polyhedral within fluent 6.3.x (it is just embedded in fluent, not in gambit)
|
|
|
|
||
|
August 8, 2007, 14:53
|
Re: Polyhedral mesh in Fluent
|
#3 |
|
Guest
Posts: n/a
|
You can also export a mesh as a polyhedral type from TGrid but this is for hexcore to convert the transitional cells. All cells will be tagged as a polyhedral type however. This is to avoid hanging nodes but these meshes cannot be read back in to TGrid/Gambit once converted.
|
|
|
|
||
|
August 22, 2007, 05:31
|
Re: Polyhedral mesh in Fluent
|
#4 |
|
Guest
Posts: n/a
|
hello. I need automobile mesh in fluent or address in internet thankful
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 07:09 |
| Fluent converting 'wall' to 'interior' BC for hybrid mesh | DarrenC | FLUENT | 8 | January 3, 2019 07:24 |
| [snappyHexMesh] SnappyHexMesh for internal Flow | vishwa | OpenFOAM Meshing & Mesh Conversion | 24 | June 27, 2016 09:54 |
| 3D Hybrid Mesh Errors | DarrenC | ANSYS Meshing & Geometry | 11 | August 5, 2013 07:42 |
| [ICEM] 2D mesh export to FLUENT | Ed Kay | ANSYS Meshing & Geometry | 0 | October 22, 2009 12:08 |
Linear Mode
