 |
 |
 |
|
|
|
[Sponsors] | ||||
August 7, 2007, 05:44
|
reversed flow
|
#1 |
|
Guest
Posts: n/a
|
Hi i want to simulate flow in 2 channel but i have bellow massega: reversed flow on 75 faces on outflow. what is it? can anyone explain about it for me? whit king regards free
|
|
|
||
|
August 7, 2007, 07:48
|
Re: reversed flow
|
#2 |
|
Guest
Posts: n/a
|
Move your boundary conditions further away from the point of interest.
|
|
|
|
||
|
August 8, 2007, 15:56
|
Re: reversed flow
|
#3 |
|
Guest
Posts: n/a
|
the pressure just inside of the outlet is lower than than applied in the boundary condition at the exit and flow is trying to re-enter the domain. Check that application of a uniform static pressure is correct but moving the boundary further is the best approach. If 3d you can use extrude-face-zone-delta inside Fluent.
|
|
|
|
||
|
August 10, 2007, 15:39
|
Re: reversed flow
|
#4 |
|
Guest
Posts: n/a
|
Hi tankx for your reply,but how can i tranfer my face in gambit or fluent? and how can i use "extrude-face-zone-delta " ? Best regards Free
|
|
|
|
||
|
February 27, 2014, 02:56
|
|
#5 |
|
New Member
Harshad
Join Date: May 2013
Location: mUMBAI
Posts: 13
Rep Power: 13  |
Hello red lemon,
If 3d you can't use extrude-face-zone-delta inside Fluent as Extruding face zones is only allowed in the 3D version of ANSYS FLUENT |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| reversed flow during RNG in turbulence-k epsilon | Suman Kandula | FLUENT | 4 | April 2, 2012 08:12 |
| Reversed flow...>>>Please HELP...! | sushii | FLUENT | 14 | October 29, 2007 05:27 |
| reversed flow at velocity inlet / mass flow inlet | ib | FLUENT | 1 | March 26, 2007 14:11 |
| reversed flow | Sastry | FLUENT | 5 | March 22, 2007 09:05 |
| Combatting reversed flow | tucker | FLUENT | 1 | July 27, 2005 02:32 |
Linear Mode
