|
[Sponsors] |
Gambit: Volume mesh starting from floating surface |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
July 31, 2007, 14:26 |
Gambit: Volume mesh starting from floating surface
|
#1 |
Guest
Posts: n/a
|
I am attempting to create a volume mesh of my domain originating from a single floating surface(with no body attached to it.)
Any suggestions on how to get Gambit to recognize this face in the context of the volume? Thanks, Peter |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 07:09 |
[Gmsh] Problem with Gmsh | nishant_hull | OpenFOAM Meshing & Mesh Conversion | 23 | August 5, 2015 03:09 |
[ICEM] Negative volume error in hybrid mesh | siw | ANSYS Meshing & Geometry | 4 | September 3, 2014 06:25 |
[ICEM] Generating Mesh for STL Car in Windtunnel Simulation | tommymoose | ANSYS Meshing & Geometry | 48 | April 15, 2013 05:24 |
[Netgen] Volume mesh instead of surface mesh | phan | OpenFOAM Meshing & Mesh Conversion | 4 | October 18, 2009 18:17 |