|
[Sponsors] |
![]() |
![]() |
#1 |
Guest
Posts: n/a
|
When I produce a shaded plot and I include the grid for showing the outline I also get the lines which shows the partition of the mesh. Is there a way of removing those lines and still shows the outline of the surface. Thanks in advance Josh
|
|
![]() |
![]() |
![]() |
#2 |
Guest
Posts: n/a
|
I forgot, I need to postproces in parallel I do not have enough memory on a single computer
|
|
![]() |
![]() |
![]() |
#3 |
Guest
Posts: n/a
|
Hey
Go to "Specify Display Atributes", second button from the left on the bottom of the page. Next to "Mesh", press Off and then "Apply". Good luck AAA |
|
![]() |
![]() |
![]() |
#4 |
Guest
Posts: n/a
|
AAA,
I think Josh is talking about Fluent display not Gambit. |
|
![]() |
![]() |
![]() |
#5 |
Guest
Posts: n/a
|
That is correct
|
|
![]() |
![]() |
![]() |
#6 |
Guest
Posts: n/a
|
Hey
What do you mean by shaded plot? Is it xy plot? contours? grid? Regards AAA |
|
![]() |
![]() |
![]() |
#7 |
Guest
Posts: n/a
|
If a create a contour plot and display the grid as outline edges then I can also see the dividing lines for the partitioning.
|
|
![]() |
![]() |
![]() |
#8 |
Guest
Posts: n/a
|
Bump - I'd also like to know the answer to this question!
|
|
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Tutorials] Tutorial of how to plot residuals ! | wolle1982 | OpenFOAM Community Contributions | 171 | February 20, 2024 02:55 |
path lines | seeta | FLUENT | 1 | September 4, 2011 01:07 |
Plotting Residuals | ata | OpenFOAM | 12 | July 8, 2011 02:50 |
how to Turning grid lines off | hsnclk | FLUENT | 1 | April 19, 2011 01:39 |
[ICEM] Mesh lines and points | Anorky | ANSYS Meshing & Geometry | 3 | December 1, 2009 00:35 |