|
[Sponsors] |
![]() |
![]() |
#1 |
Guest
Posts: n/a
|
hi i am working on CFD of an mav . when i make the domain by just subtracting the mav from a cube, the resulting volume can be free meshed but only in course.
when i give a fine msh over the mav wall and then try to msh the vol, it says "perturb failed... check ur mesh in areas of small gaps" secondly when i msh any line , the nodes instead of being on the line go away from it ne body who can help |
|
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] surface mesh merging problem | everest | ANSYS Meshing & Geometry | 44 | April 14, 2016 06:41 |
Mesh motion with Translation & Rotation | Doginal | CFX | 2 | January 12, 2014 06:21 |
3D Hybrid Mesh Errors | DarrenC | ANSYS Meshing & Geometry | 11 | August 5, 2013 06:42 |
Generating a volume mesh | samiam1000 | Main CFD Forum | 0 | October 25, 2010 11:18 |
Cannot mesh volume | Wendy Tjan | FLUENT | 4 | December 11, 2008 06:03 |