 |
 |
 |
|
|
|
[Sponsors] | ||||
June 21, 2007, 02:18
|
How to set a UDS for ht transfer coef,'h'??
|
#1 |
|
Guest
Posts: n/a
|
I need to set a UDS for heat transfer coeff 'h', along a particular boundary such tat it varies with temp as h=c*T^n..... How do i go about this? Which help file is relevant that has to be referred? Pls help since i am a new user of FLUENT n would love to know how to solve this problem... Thanks in advance. Akshay
|
|
|
||
|
June 21, 2007, 04:19
|
Re: How to set a UDS for ht transfer coef,'h'??
|
#2 |
|
Guest
Posts: n/a
|
Hello
write a UDF ,say my_htc, and hook it in thermal boundary condition panel (select convection from the thermal conditions) ... I am not sure but I think it would be taken by fluent as heat transfer coefficient... due to time constraint I am unable to check it myself.. hope it will help...do let me know if it worked or not.. Jack ... |
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| OF 1.6 | Ubuntu 9.10 (64bit) | GLIBCXX_3.4.11 not found | piprus | OpenFOAM Installation | 22 | February 25, 2010 14:43 |
| Compiling OpenFOAM13 on AMD64 with Redhat Enterprise | mbeaudoin | OpenFOAM Installation | 20 | June 17, 2008 07:43 |
| Env variable not set | gruber2 | OpenFOAM Installation | 5 | December 30, 2005 05:27 |
| Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 16:55 |
| additional variable mass transfer in CFX5.6 | john | CFX | 1 | February 14, 2004 01:30 |
Linear Mode
