|
[Sponsors] |
![]() |
![]() |
#1 |
Guest
Posts: n/a
|
Hi,
I'm a student trying to model a propeller that is inside a volume. The thing is that I've set this propeller as a flat disk, but when I try to mesh the volume, these cells of the propeller are not taken in account. I've declared the disk as interior face, but the nodes are still not "taken" by Gambit to build the 3d mesh in that volume. Any suggestion is welcomed. PD: in general, how to mesh a volume with an unlinked flat surface in it? |
|
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 06:09 |
[blockMesh] BlockMesh FOAM warning | gaottino | OpenFOAM Meshing & Mesh Conversion | 7 | July 19, 2010 14:11 |
On the damBreak4phaseFine cases | paean | OpenFOAM Running, Solving & CFD | 0 | November 14, 2008 21:14 |
fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |
[blockMesh] Axisymmetrical mesh | Rasmus Gjesing (Gjesing) | OpenFOAM Meshing & Mesh Conversion | 10 | April 2, 2007 14:00 |